Titanium wire manual hand TIG welding operation essentials
1, manual argon arc welding, welding wire and welding parts should try to keep the minimum angle (10 ~ 15 °). The wire is smoothly and evenly fed into the bath along the front of the bath. The ends of the wire shall not be removed from the argon protection zone.
2, welding, the torch basically do not make horizontal swing, when the need to swing, the frequency is low, the swing range should not be too much to prevent the impact of argon protection.
3, broken arc and the end of the weld, to continue with argon protection, until the weld and heat affected area of metal cooling to 350 ℃ below when the gun can be removed.
Specifications and Standards for Titanium Wire/Welded Wire and its Alloys